Kloubová oka Fluro

13 FLURO ® -Gelenklager GmbH Ordering Details On pages 5 to 10 we have given full details of our standard range of products. Additional notes to make sure details are correct when placing orders are listed below; additions to and deviations from our standard program are listed, as well. Female Thread: The letter i is situated in the second place in the reference e.g. G i or E i Male Thread: The letter A is situated in the second place in the reference e.g. G A or E A left Hand Thread: The letter l is situated in the third place in the reference e.g. GA l or EA l Non-Standard Thread: Bearing reference with additional thread specification e.g. GISW 30, M 27x2 Stainless Steel Ball: The letter R will be added after size reference e.g. GIRSW 10 R , GXSW 10 R , stainless version (stainless type see pages 32, 40, 58, 61, 65, 67) Completely Stainless The letters RR will be added after size reference (Series K): e.g. GARSW 16 RR, GXSW 16 RR (all items in stainless steel) Completely Stainless The letters NiRo will be added after size reference (Series E): e.g. GE 10 EC -NiRo or EI 16 D -NiRo Ball Hard Chrome Plated: iCR will be added after size reference e.g. GASW 10 iCR Seal: -2RS will be added after size reference e.g. GISW 10 -2RS (see pages 52) Threaded Bolt: Bo will be added after size reference e.g. GISW 10 Bo (for right angle use, see page 53) Nickel Plated Housing: Ni will be added after size reference e.g. GISW 14 Ni (improved corrosion resistance for the housing) for series on pages 26 to 29, 34 to 37 Special Grease Nipples: SN will be added after size reference e.g. GAS 16 SN DIN 71412 H1/A M6x1 (exact name of grease nipple has to be specified) left Hand Thread for The letter l will be added at the third place replacing the letter R Hydraulic Rod Ends: e.g. FPl...N, except for series FMA...D = FMAl...D For sizes deviating from the standard or for specials, please send us your drawing or sketch – see template on page 116. The maintenance instructions, selection criteria, tolerances and calculations as shown in the following technical section are intended to be an important guideline for the choice of the correct bearing to suit the particular application of our Rod Ends and Spherical Plain Bearings.